Mindray VS-900, Руководство оператора

Страница: 32 / 192

2-12
To exit Standby mode, you can take any one of the following ways:

Press the any hardkey on the panel.

Rotate the knob.

Connect SpO
2
sensor, and let the monitor receive SpO
2
signal for more than 5
seconds.

Remove the temperature probe from the probe well.
NOTE

If the monitor enters and then exits Standby mode during patient monitoring,
you must re-admit the patient for the monitoring.
2.6.4 Demo Mode
Demo mode is password protected, and it is used for demonstration purpose only.
To enter Demo mode:
1. Select [ Main ]
→
[ Maintenance>> ].
2. Select [ Demo>> ]
→
Enter required password
→
Select [ Ok ].
To exit Demo mode:
1. Select [ Main ]
→
[ Maintenance>> ].
2. Select [ Exit Demo ].
WARNING

The Demo mode is for demonstration purpose only. To avoid that the simulated
data are mistaken for the monitored patient’s data, you must not change into
Demo mode during monitoring. Otherwise, improper patient monitoring and
delayed treatment could result.