Mindray VS-900, Руководство оператора

Страница: 120 / 192

14-2
In the Monitor Network Setup menu, you can:

Set [
Network Type
] to [
LAN
] or [
WLAN
].

Set [ Address Type ] to [ DHCP ] or [ Manual ].

If [ Address Type ] is set to [ DHCP ], the monitor can automatically acquire
network parameters.

If [ Address Type ] is set to [ Manual ], you need to manually input the monitor IP
address, subnet mask and gateway address.
14.2.1 Wireless Network
The patient monitors can be connected to a wireless network via a built-in Wi-Fi module.
To set the wireless network:
1. Select [ Main ]
→
[ Maintenance>> ]
→
[ User Settings >> ]
→
enter the required
password
→
Select [ Ok ]
→
[ Network Setup >> ]
→
[ Monitor Network Setup >> ].
2. Set the [ Network Type ] to [ WLAN ].
3. Select [ WLAN Setup >> ] to access the WLAN setup menu.
4. Configure the [ Network Name (SSID) ], [ Security ] and [ Password ].
5. Click [ OK ] to confirm the setting.
14.2.2 WLAN Test
To test the availability of the wireless network, follow this procedure:
1. Select [ WLAN Test >> ] in the [ Network Setup ] menu.
2. Enter the [ IP Address ] of wireless AP in the [ WLAN Test >> ] menu.
3. Click [ Connection Test ].
The Wi-Fi device used in the monitor is in compliance with IEEE 802.11a/b/g/n.
You should not change the patient monitor’s IP address randomly. If you want to know
details about IP address setup, contact the technical personnel in charge of the CMS.
NOTE

The design, installation, restruction and maintenance of the wireless network’s
distribution shall be performed by authorized service personnel of our
company.

The existence of obstacles (such as wall) will exert impact on data transferring
or even cause network interruption.

An access point (AP) supports a maximum of 16 monitors through wireless
network.

Keep network authentication information (e.g, password) safe to protect the