MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 96 / 110

– 4.4 –
ERR02 MAIN RAM
ERR04 EEPROM
ERR06 BUFFER
ERR08 POWER
ERR10 COMMAND
ERR11 PARAMETER
ERR12 DEVICE
ERR13 PM OVER
ERR15 AUTO FEED
ERR20 I/O
ERR27 BUFFERover
TROUBLE FOR WHICH ERROR MESSAGES ARE
GIVEN ON THE LCD
If something is wrong with the device, a corresponding error message is given on the LCD.
Take an appropriate corrective measure according to the remedies given in the table below.
Trouble has occurred in the control
RAM.
Trouble has occurred in the system
ROM.
Trouble has occurred in the receiver
buffer.
Trouble related to the motor has
occurred.
Code other than command data have
been received.
A parameter outside the numerical
limits has been received.
The device received an improper
device control command.
Data on polygon has overflown the
polygon buffer.
The device has failed to feed the
sheet by the length specified with
ZX command.
During division cut, the device has
failed to feed the sheet, according to
the second data, by the length
specified by the first data.
Communication conditions are
wrong.
The interface is faulty.
Error message Cause Action
Please call your dealer or our
company’s sales office for service.
Check up the command data sent
from the host computer.
Check up the parameter.
Check up the device control
command.
Divide the data on polygon.
After the receipt of data sent from
the host computer, replace the sheet
with a longer-dimension one and
execute the plural sheets cutting.
Load a longer sheet on the device
and re-set the device in the remote
mode.
Establish the same communication
conditions with those established on
the host computer.
Establish the same communication
conditions with those established on
the host computer or check up the
interface cable.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○