MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 72 / 110

– 3.22 –
• In any of the following case, the device will cut neither the frame nor the adhesion
allowance marks.
a) Where the capacity of data is larger than the receiver buffer capacity
b) Where the origin updating command is contained in the data on cutting
c) Where the two-point correcting function is specified
d) Where the width of effective cutting area is 1 cm or less
e) Where the device cuts the test data stored in it
The following display will appear on the LCD panel.
1) Set the [DIVISIONcut] to the ON state.
2) Send data from the host computer to
the device.
If the data exceeds the cutting area, the display
given on the left will appear on the LCD.
3) Upon completion of cutting, wait until
the device cuts the frame and adhesion
allowance mark.
Remaining time until the completion of cutting
the frame and mark
4) Upon completion of the frame cutting,
the device will enter the local mode.
The display shown on the left will appear on
the LCD panel.
* Do not raise the clamp lever while
t h e L C D p a n e l g i v e s t h e
aforementioned display. If you
raise the clamp lever, the machine
will terminate cutting.
Origin
Effective
area
Mark
The time required to cut the frame and
adhesion allowance mark will appear
on the LCD panel.
**
END DIVISION
**
**
OFF SCALE
**
**
DIVISION
**
XXs
CUT1 DIVISION