MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 80 / 110

– 3.30 –
Detecting a registration mark on a sheet
The printed seal (hereinafter referred to as the “sheet”) are required to be printed with marks that
satisfy the following requirements to allow the device to detect the registration mark as well as the
length of A- and B-axis.
If not, the device will not produce a desired result.
* The registration mark described in this paragraph means a registration mark
that is used to detect the sheet inclination and the length of A- and B-axis. It is
different from a mark for trimming.
* The mark shall be printed in black against the white background.
* The line width of mark shall be equal to or more than 0.3 mm and equal to or
less than 0.5 m.
* To detect the registration marks, no stain or print image should be in between
the marks.
* TP3 is used for the distance correction in widthwise direction of the sheet. If the
distance correction in widthwise direction of the sheet need not be made, the
detection of TP3 may be omitted.
Pinch roller
30 mm or more from
the sheet backend
B: 50 mm or more
A: 50 - 2000 mm
Printable, cuttable range
Keep the marks away
from the image.
40 mm or more from
the sheet backend
20 mm or more from
the sheet
TYPE1