MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 31 / 110

– 2.9 –
Operation modes
The device operates under three different operation modes as shown below.
Not-ready mode
When the power is turned on, the device enters the not-ready mode and stays there until a sheet of
media is detected. The keys other than the and keys are effective. The function to
enable operations of the jog keys or plotter is not effective. (Such as in the case of executing test
cutting or sample cutting)
If you executed any of the aforementioned disabled function, the following message will appear on
the LCD.
Local mode
The device enters the local mode after the sheet detection.
Normally, tool conditions appear on the display panel. Under the local mode, all keys are effective
to enable setups.
The device is able to receive data sent from the host computer, however, it will not perform cutting
(plotting).
Example of display
Remote mode
The device performs cutting (plotting) under this mode.
The key and keys are effective.
If you press the key during cutting (plotting), the device will be put on hold. Another press
on the same key will allow the device to resume cutting (plotting).
If you press the key while the device is put on hold, the hold function that corrects the
sheet that has slipped out of position (see page 3-11).
Example of display
The power
is turned on.
Sheet detection
Not ready
mode
Local mode
Raise the
lever.
Remote
mode
Raise the lever.
REMOTE
LOCAL
REMOTE
LOCAL
REMOTE
LOCAL
AUTO
FEED
ENTER
HOLD
ENTER
HOLD
CUT1 20 040 0.30
ERR30 OPERATION
CUT1
**
REMOTE
**