MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 84 / 110

– 3.34 –
3) Taking care not to allow the sheet to slip
out of position, turn the sheet set lever
toward you.
Then, the pinch rollers will retain the sheet.
4) Press the key.
The detection of TP1, TP2 and TP will start.
• In the case where TP3 is not required
to be detected, refer to “Operation
settings for detection of marks.”
If any of the marks cannot be detected, the
message shown on the left will appear on the
LCD. In this case, set the sheet properly.
5) After the marks are detected, lengths A
and B will be shown on the LCD.
• In the case where the [DIST.COMP]
is set to “OFF,” the length-input
screen will not appear on the LCD.
• In the case where the [MARK
DETECT] is set to “A,” the screen
on which length B is to be input will
not appear on the LCD.
If the lengths A and B displayed on the LCD
are different from those contained in the data,
input the latter using the
or key and
press the key to enter the lengths.
If the lengths A and B shown on the LCD are
same with those contained in the data, press
also the
key.
When the key is pressed, the screen
on which length B is to be input will appear on
the LCD.
6) Input length B.
If the length B shown on the LCD is different
from that contained in the data, input the latter
using the
or key and press the
key to enter the length input..
If the length B that appears on the LCD is same
with that contained in the data, press also the
key.
ERR36 MARKdetect
A = ***. * B = ***. *
** MARK DETECT **
ROLL < R > LEAF
A = ***. * B = ***. *