MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 17 / 110

– 1.7 –
4) AC inlet
The power cable is connected to the AC inlet.
5) Power switch
It turn on/off the power.
6) Carriage
The carriage travels from side to side while holding a tool. It is also used to raise/lower the tool.
7) Pen line rubber
The device performs cutting or plotting on the pen line rubber.
8) Pen line sponge
The device performs pouncing on the pen line sponge.
9) Sheet sensor
It detects the presence of the sheet and sheet length.
10) Scale
The scale is used as a guide when loading a sheet of medium on the device. It is used in
combination with the rear scale.
11) Grid roller
The grid rollers operate in combination with the pinch rollers to feed out the sheet.
12) Pinch roller
The pinch rollers can be moved to the right or left to adapt to the size of sheet to be used. The
pinch rollers feed out the sheet while pressing it against the corresponding grid rollers.
13) “PINCH ROLLER SETTINGS” Mark
The marks indicate the locations at which the pinch rollers are set.
14) Platen
The sheet of medium moves along the platen.
15) Clamp lever
This lever is used to adjust the force by which the clamp is held.
16) Roll stay
Roll stays support the roll bars.
17) Roll bar
A roll sheet is placed on the two roll bars.
18) Turn-back lever
In the case where two rolls of sheet are loaded on the device, the turn-back lever works to
prevent the lower roll sheet from coming in contact with the upper roll sheet.
19) RS-232C interface connector
The RS-232C compatible interface connector. It is connected to the RS-232C connector of the
host computer via an interface cable.
20) 8 bit parallel interface connector
The Centronics compatible interface connector. It is connected to the printer connector of the
host computer via an interface cable.