MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 69 / 110

– 3.19 –
Change-over of cut mode [CUT MODE]
This function is used to specify the cutting quality.
Setting value (Make a choice and input it)
QUALITY : The device conducts cutting giving priority to the cutting quality.
NORMAL : The device conducts cutting normally.
HIGHspd : The device conducts cutting quickly.
• Select the “QUALITY” in the following cases:
a) Where a character of which size is 10 mm or less is to be cut
b) Where a picture pattern or character that have many sharp curves is to be cut
c) Where minute cutting is to be performed
It should be noted, however, that a pattern with a rugged edges may be finished in the case
where the data sent from the host computer is excessively minute. It is recommended in such
a case to select the “HIGHspd” for smoother finish.
Guide for the case where the operating procedure of the 8-bit parallel interface is set to [BUFFER]:
•
In the case where the host computer offers high-speed data transfer and it is desired to reduce
the time of the host computer occupied by data transfer
•
In the case where the device performs cutting intermittently since it receives data and performs
cutting simultaneously ([NORMAL]). In the case where the performance of the device when
conducting cutting according to the received data and that when conducting the plural sheets
cutting independently from the host computer differ from each other.
[Close time]
The minimum waiting time is required until the subsequent data is received.
The setting range is 3 to 60 seconds. If no data is received when the established waiting time has
elapsed after the completion of cutting, the device will judge that one piece of data has com-
pleted to enable discrimination between the completed data and the subsequent data.
Guide to the establishment of close time.
• Breakpoint in object data to be cut by piece-cutting feature
• Waiting time Required to start division-cutting
• Waiting time retired to start outputting a sorting command