MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 106 / 110

– A.6 –
SPECIFICATIONS OF THE MAIN UNIT
Item CG-60EX CG-100EX CG-130EX
Acceptable sheet width mm inch mm inch mm inch
100~624 24 110 ~ 711 24 110 ~ 711 24
755 ~ 912 30 755 ~ 1070 36, 36, 42
871 ~ 1028 36, 42 1167 ~ 1324 48, 50, 52
Effective cutting area (note 1) 600 mm x 51 m 1005 mm x 51 m 1300 mm x 51 m
Maximum cutting speed (note 2) 80 cm/s
Speed setting 1 to 10 cm/s (in 1 cm/s steps), 10 to 40 cm/s (in 5 cm/s steps)
(cutting/plotting) (note 2) 40 to 80 cm/s (in 10 cm/s steps)
Mechanical resolution 5 µ m (excluding expansion/contraction due to film temperatures)
Program steps 25 µ m, 10 µ m
Repeatability ± 0.2 mm (excluding expansion/contraction due to film temperatures)
Guaranteed range of 600 mm x 10 m 1005 mm x 10 m 1300 mm x 10 m
accuracy (repeatability) (note 5) (depending on the (depending on the (depending on the
specified film and specified film and specified film and
cutting conditions) cutting conditions) cutting conditions)
Maximum pressure 300 g
Cutter 10 ~ 20 g (2 g step), 20 ~ 100 g (5 g step), 100 ~ 300 g (10 g step)
Pressure setting Pin 10 ~ 20 g (2 g step), 20 ~ 100 g (5 g step), 100 ~ 300 g (10 g step)
Pen 10 ~ 20 g (2 g step), 20 ~ 100 g (5 g step), 100 ~ 150 g (10 g step)
Acceptable films PVC sheets (0.2 mm thick or less), fluorescent sheets, reflective sheets (note 3),
laminated sheets (0.2 mm thick or less)
Acceptable sheet for pouncing Paper (thickness: 0.06 to 0.13 mm) (note 4)
Applicable tools Cutters, water-ink ball-point pens and oil-ink ball-point pens
Commands MGL-IIc
Interface RS-232C, 8-bit parallel
Receiver buffer 2 MB standard
Operating environment 5 to 35 ° C, 35 to 75 % (Rh) Non-condensing
Power capacity 220/240 VAC, 170 VA or less
Outside dimensions 1030 (W) x 438 (D) 1430 (W) x 610 (D) 1730 (WW) x 610 (D)
x 390 (H) provided x 1160 (H) x 1160 (H)
with a roll stand.
Weight 26 kg 50 kg 58 kg
(provided with stands) (provided with stands)
•
Notes Refer to the next page for the explanation of notes 1 to 5.
(Note 1) : The maximum feeding length is restricted by the software to be used.
(Note 2) : The maximum speed may be restricted by the sheet size.
(Note 3) : Provided that the blade specific to fluorescent sheets and the blade specific to reflective
sheets are used.
(Note 4) : Pouncing tool intended specifically to pouncing shall be used.
(Note 5) : To achieve the guaranteed range of accuracy, the following requirements shall be satisfied.