MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 61 / 110

– 3.11 –
Hold
In the case where the sheet slips out of position during cutting (plotting) of long-distance data, the
hold function is used to put the device on hold to allow the operator to correct the displacement of
the sheet and re-start the operation after the completion of correction.
A press on the key during cutting (plotting) will put the device on hold.
• Under the local mode, the ENTER/HOLD key has to be held pressed for
approximately 1.5 seconds.
* Be sure to execute the hold function at the boundary between characters.
If you execute the hold function while the device is cutting (plotting) a line segment
of a character, the starting point and end point of cutting (plotting) will not meet.
* When correcting the displacement of the sheet, move neither the carriage nor the
pinch rollers. If they are moved out of position, a damage to the device or an error
will arise.
* After the device is put on hold, lower the pinch rollers. If they are held raised, the
hold function cannot be terminated.
Half cut
When cutting the sheet according to data, the device cuts the data in broken lines without cutting it
out.
In addition, the “auto cut” can be specified to cut out the sheet automatically upon completion
cutting. To conduct the broken-line cutting, place the tool on this side of the tool holder and set the
cutting conditions to “HALF.”
* For the broken-line cutting, use the cutter (model: SPB-0001, a set of three
cemented carbide blades) that is optionally available.
Setting value
Half cut (Setting of broken-line cutting) : ON, OFF
Auto cut (Automatic cut-off of sheet) : ON, OFF
Half cut press (Cutting pressure to cut out the sheet) : 0 g to 80 g
Half cut length (Length of sheet to remain after cutting) : 0.1 mm to 5.0 mm
Cut length (Length by which the sheet is cut out.) : 5 to 150 mm
Data after the correction of
displacement of sheet
– – HOLD – –