Page
16
of
33
Slide the 1465 extrusion into the 2650 extrusion. Repeat the process with
(5) of the remaining (6) 1465 extrusion. Keep the corner joiners pointing
the same way, towards the opposite end of the 2650 extrusion. The spacing
of the extrusion is about 371.66mm (14 5/8”) between the extrusions.
The
last extrusion should be inserted into the other end of the 2650 extrusion
with the corner joiners pointing towards the opposite end.
Make sure the frame is square. Make sure the 1465 extrusion is flush with
the top of the 2650 extrusion. In the case of the front and rear 1465
extrusion, make sure the outside is flush with the ends of the 2650
extrusion. Tighten the set screws for the inside corner joiners.
The gussets will connect the 1465 extrusion to the 2650 extrusion on the
side opposite of the inside corner joiners. Place (2) drop-in t nuts, one in
each slot, on each end of the 1465 extrusions for a total of 4 drop-ins for
each extrusion. The front and back extrusions will have the gussets on the
same side as the inside corner joiners. Place (2) corresponding drop-in t
nuts in the 2650 extrusion for each set in the 1465 extrusion.
Using the M5x8 Button cap screws, attach the gussets to the 1465 Extrusion
and the 2650 extrusion. There will be (2) gussets for each 1465 extrusion,
one on either end, for a total of (14) gussets.
