Page
28
of
33
On the right side of the Mega V X extrusion, place a drop-in t nut. Put a split
lock washer on the M5x30 machine screw. Put the screw through the L
bracket (same side as the switch), then through the large homing spacer
and secure it to the Mega V X extrusion. The switch should be positioned so
the edge of the X motor mount will engage the switch before end of travel.
This is the X switch.
The homing wires are marked near the end close to the spade connectors. The black wire will connect to the
terminal exiting the side of the switch and curving down, pictured above. The red wire will connect to the
terminal closest to the black terminal. Connect the Z and X switches. Leave the Y switch alone for now.
DeWalt Router
Parts
DeWalt 618 Router
Hardware
Needed Hardware is already installed
Tools
3/16 Hex Key
Take the DW618 router from the box and remove all plastic pieces from the barrel. Loosen the 5/16x1 button
cap screws on the front of the router mount. Slide the 618 router into the router mount about 1/3 of the way
up the barrel of the router. Make sure the on/off switch of the router is accessible from the front of the
machine. Tighten the 5/16x1 button cap screws a little at a time until fully secure. Do not tighten one side
down completely before tightening the other side.
