Page
26
of
33
Homing Switches
Parts
Homing Kit (parts listed on homing sheet
inventory)
Hardware
Homing Kit
Tools
2mm Hex Key
3mm Hex Key
Phillips-Head Screwdriver
Needle Nose Pliers
Locate the long paddle switch. Locate printed extender piece. Slide the extender onto the paddle with the
screw hole facing the switch and the printed extender out towards the red side of the switch (shown above).
Insert a M3x8 button cap screw to secure the printed extender to the paddle.
Run the Z axis down by rotating the
coupler. There will be two holes at the top
right of the X plate on either side of the
right Z rail. Insert (2) M3x20 machines
screw in the holes. Place the long paddle
switch on the M3x20 screws on the back of
the X plate as shown (red side of the switch
against the plate). Secure with M3 nylock
nuts.
Insert the M5x35 machine screw into the Z
engager bracket on the Z plate. Place a M5
split lock washer on the screw and thread
the M5 hex nut on. Tighten the screw near
the top of the engager bracket. Move the Z
axis up and line up the printed extender
with the M5x35 screw and tighten the
printed extender. This is the Z switch.
