Page
14
of
33
Locate the (2) Y mid-span supports. In the middle of the 2650 Mega V
extrusion (1325mm), opposite the rack, place (2) drop-in t nuts in each
extrusion. Place M5 split lock washers on (4) M5x25 button cap screws.
Attach the Y mid-span supports to the 2650 extrusion using the M5x25
button caps with split lock washers and the drop-in t nuts. Orientation of
the Y mid-span support does not matter.
Retrieve the X/Z assembly. The mount is the bottom of the assembly, and
the motor is the top. The v-wheels will pinch the outside of the Mega V
extrusion using the v shaped slots on the top and bottom. If the v-wheels
are too tight to slide on the extrusion, use a 13mm wrench to turn the
eccentrics until the assembly slides onto the extrusion. Slide the X/Z
assembly onto the same side of the 1465 extrusion as the logo. Set the
2650 extrusion to the side being careful not to bend the drag chain mount.
Retrieve the left end plate. On the left side of the extrusion, use (4) 5/16 x
3/4 button cap screws to attach the left end plate to the extrusion. Repeat
the process on the right side with the right end plate. The end plates should
extend more from the front of the extrusion than the back. Set the 1460
Gantry to the side being carful not to bend the drag chain mounts.