Page
27
of
33
Locate the long roller switch and a L
bracket. Place the red part of the switch on
the L bracket with the roller facing the flat
side of the L bracket. Place (2) M3x20
machine screws through the black side of
the switch and secure with (2) M3 nylock
nuts.
Place an M5x12 machine screw through the slot on the 90* bracket and
then through the hole in the L bracket and secure with a M5 nylock nut.
The 90* bracket is opposite the switch.
In the top of the rear 1465 Extrusion, in the
first slot, place a drop-in t nut. Secure the
90* slot to the 1465 extrusion using a
M5x12 machine screw with a M5 split lock
washer. The edge of the right gantry end
plate (on the left as viewed from the rear
of the machine) should engage the switch
near the end of travel. This is the Y switch.
Locate the short roller switch and a L bracket. Place the red part of the
switch on the L bracket with the roller facing the flat side of the L bracket.
Place (2) M3x20 machine screws through the black side of the switch and
secure with (2) M3 nylock nuts.
