eGROSS pro-x - eGROSS
MM137-004 - Operator Manual
38
Then the power button on the lateral left side must be pressed as shown in the image below. This button is
also used to turn off the eGROSS unit. The Ethernet/LAN connection (for the eGROSS pro-x version only) can
be found next to the ON/OFF button.
To finish the installation of eGROSS, assemble the equipment holder beam on the back-top part of the cap (6
M8 screws) and the polycarbonate sheet (15 countersunk M6 screws), as shown in the figure below.
Finally, assemble the Glove Holder included in the unit on the equipment holder beam.
Fix it with 2 nuts, washers and M6 screws supplied together with the Glove Dispenser.
Follow these steps below:
- After deciding where you want to assemble the Glove Dispenser on the beam, prize to extract the green
profile.
- The distance between the nuts must correspond to the distance of the holes on the Glove Dispenser.
Unit ON/OFF button
Ethernet/LAN connection
(for the eGROSS pro-x
only)
Two outlets
for connecting
instruments
Instrument
label
