Mhouse MhouseKit WS2S, Руководство по установке, Страница: 32 / 36

30
04. Then move the gate manually.
05. To reset the automation turn the key clockwise and at the
same time move the gate until you hear the carriage engage.
06. Remove the key and close the release cap cover by turning it
clockwise.
11.4 - Maintenance operations admissible to the
user
The operations that must be periodically performed by the user
are listed below.
• Use a slightly damp cloth (not wet) to clean the surface
of the devices. Do not use any substances containing alco-
hol, benzene, diluents or other flammable substances. The
use of these substances could damage the devices, start
fires or generate electric shocks.
• Disconnect the power supply to the automation before
you proceed to remove leaves and debris, to prevent any-
one from activating the door.
• Periodically check the system, especially cables, springs
and supports, for possible imbalance or signs of wear
or damage. Do not use the automation system if repair
or adjustment is necessary, in as much that a fault or an
incorrectly balanced door could cause injury.
11.5 - Remote control battery replacement (fig. 43)
When the battery charge is low, the range of the transmitter is
significantly reduced. When a key is pressed, if led L1 illuminates
and then immediately fades and turns off, this means that the bat-
tery is completely discharged and must be replaced immediately.
Otherwise if led L1 illuminates briefly, this means that the battery
charge is low; in this case press and hold the key for at least
half a second to enable the transmitter to attempt delivery of the
command. In any case, if the battery is too low to complete the
command (and possibly wait for the response), the transmitter
turns off with the L1 LED, which dims. In these cases, to restore
the regular operation of the transmitter it is necessary to replace
the exhausted battery with one of the same type, respecting the
polarity indicated.
The batteries contain polluting substances: do not dispose
of them together with other waste but use the methods
established by local regulations.
11.6 - Remote control support installation
To install the remote control support, see fig. 44 .
42
44
43