Mhouse MhouseKit WS2S, Руководство по установке

Страница: 15 / 36

13
A
B
C
A
B
TESTING AND COMMISSIONING
through the optic axis, first close to the TX and then the RX and then
mid-way between the two. Ensure that in all cases the device engag-
es, changing from the active status to alarm status and vice versa;
then ensure that the action envisaged is performed on the control
unit: that it inverts movement during closure.
05. Measure the force as specified in the standard EN 12445. If the motor
force control is used as an auxiliary function for reduction of impact
force, test and identify the setting that obtains the best results.
––– STEP 8 –––
These are the most important operations, designed to guarantee the
maximum safety and reliability of the automation system.
The testing procedure can also be used as a periodic check of the devic-
es that make up the automation.
The testing and commissioning operations must be performed
by qualified and experienced personnel who must establish what
tests should be conducted based on the risks involved, and verify
the compliance of the system with applicable regulations, legis-
lation and standards, in particular with all the provisions of EN
standard 12445 which establishes the test methods for testing
automations for power-operated gates.
8.1 - TESTING
01. Ensure that all instructions and warnings in STEP 1 have been
strictly observed.
02. Using the selector or radio transmitter, test gate opening and closing
and ensure that leaf movement corresponds to the envisaged com-
mands. Test several times to assess smooth operation of the gate
and check for any defects in assembly or adjustment and any pos-
sible points of friction.
03. Check operation of all system safety devices one at a time (photo-
cells, sensitive edges, etc.). In particular, each time a device trips,
the “ECSBus” led on the control unit emits a longer flash to confirm
control unit recognition of the event.
04. To test photocells and in particular that there is no interference with
other devices, pass a cylinder ( fig. 28 ) (diameter 5 cm, length 30 cm)
28
24 23
A
B
25
A
B
27 26
T1
T2
T3
T4