Mercury 135 Verado FourStroke, Руководство по эксплуатации и обслуживанию

Страница: 74 / 123

• Check the remote control cable adjustment, if applicable—dealer item
• Replace the high‑pressure fuel filter—dealer item
• Replace the accessory drive belt—dealer item
• Check the power trim fluid level—dealer item
• Inspect the engine motor mounts—dealer item
Flushing the Cooling System
Flush the internal water passages of the outboard with fresh water after each
use in salt, polluted, or muddy water. This will help prevent a buildup of
deposits from clogging the internal water passages.
NOTE: The outboard can be tilted or in the vertical operating position during
flushing.
1. With the engine turned off, place the outboard in either the operating
position (vertical) or in a tilted position.
2. Remove the flush connector from the bottom cowl.
3. Remove the cover from the flush connector and thread a water hose into
the flush connector.
14810
4. Turn on the water tap (1/2 maximum) and let the water flush through the
cooling system for about 15 minutes.
5. When flushing is complete, turn off water and disconnect the water hose.
6. Install the cover on the flush connector. Place the flush connector back
into the bottom cowl.
MAINTENANCE
64
eng