![Mercedes-Benz Metris 2021 Скачать руководство пользователя страница 145](http://html1.mh-extra.com/html/mercedes-benz/metris-2021/metris-2021_operating-instructions-manual_1771777145.webp)
Settings menu
Requirements:
R
The vehicle is stationary.
Use the buttons on the instrument cluster to
operate the on-board computer.
Introduction
#
To display the Settings menu: use the
È
button to select the
Settings
menu.
Use the
3
button to scroll through the menu and
select its submenus or functions successively.
If you press the
È
button in a submenu, the sub‐
menu or function will be exited without the set‐
ting being adopted.
Depending on the equipment, the following is
possible:
R
Setting the language of the display messages
and displays
R
Switching ESP
®
on/off (
/
page 111, 112)
R
Setting the sensitivity of the rain sensor
R
Switching ATTENTION ASSIST on/off
(
/
page 128)
R
Setting the unit for distance, consumption
and speed displays
R
Setting the time and date
#
To reset to factory settings: turn the key to
position
1
in the ignition lock and, in the
Settings
menu, press and hold the
3
button
for at least five seconds.
For safety reasons, not all functions will be reset.
Setting the display language
#
Press
3
to select the
Language:
submenu.
The display will show the current language
selection.
#
Use the
f
or
g
button to select a language.
#
Press the
3
button to confirm.
The next submenu will be shown on the dis‐
play.
Setting the sensitivity of the rain sensor
#
Press the
3
button to select the
Rain Sen-
sor:
submenu.
The display will show the current sensitivity
setting.
#
Use the
f
or
g
button to select the
Low
,
Standard
or
High
setting.
This setting controls the rain sensor's sensi‐
tivity to precipitation. This results in the wind‐
shield wipers wiping more or less often at the
same precipitation intensity.
#
Press the
3
button to confirm.
The next submenu will be shown on the dis‐
play.
%
You can find further information under "Wind‐
shield wipers" (
/
page 85).
Selecting the permanent display function
For all countries except the United Kingdom:
Using the
Permanent Display:
function, you can
switch the header of the display between outside
temperature and speed (additional speedometer).
When the display shows the speed in the header,
the outside temperature is shown with the odom‐
eters.
The additional speedometer unit in the header is
always the inverse of the speedometer unit.
#
Press the
3
button to select the
Permanent
Display:
submenu.
The display will show the current setting.
#
Change the setting by pressing the
f
or
g
button.
#
Press the
3
button to confirm.
The next submenu will be shown on the dis‐
play.
Selecting the unit of measurement for dis‐
tance
You can select whether the display shows some
information in miles or kilometers.
#
Press the
3
button to select the
Distance
Unit:
submenu.
The display will show the current setting.
#
Change the setting by pressing the
f
or
g
button.
#
Press the
3
button to confirm.
The display will show the next submenu or
the
Settings
menu again.
The selected unit of measurement for dis‐
tance applies to the following displays:
R
Digital speedometer
R
Total distance and trip distance
R
Trip computer
R
Range
R
Current consumption
Instrument cluster and on-board computer 143