The drive system can be started using another vehicle.
R
Only use batteries with an equal nominal voltage (12 volts).
R
Make sure that the battery of the donor vehicle does not have a significantly lower capacity than
the discharged battery.
R
Use jump leads with a sufficient cross-section and insulated terminal clamps from a qualified
specialist workshop, e.g. a Mercedes-Benz Service Centre.
R
Make sure that the two vehicles do not touch.
R
Route the jump leads so that they cannot be caught by rotating components in the engine com-
partment.
R
Do not disconnect the discharged battery from the vehicle's electrical system.
X
Switch off the engine of both vehicles.
X
Shift the transmission to position P.
X
Switch off all electrical consumers.
X
Remove battery cover
:
.
X
Connect positive terminal
;
on the vehicle with the flat battery to positive terminal
=
of the
donor vehicle using the red jump lead. Begin with the flat battery.
X
Connect negative terminal
?
of the donor vehicle to negative terminal
A
of the vehicle with the
flat battery using the black jump lead. Begin with donor vehicle's battery
B
.
X
Start the engine of the donor vehicle and run it at idling speed.
X
Switch on the ignition in the vehicle with the flat battery.
X
If the drive system cannot be activated immediately, wait for approximately 60 seconds between
starting attempts.
If the drive system does not start, call a breakdown service.
i
Jump-starting cables and further information regarding jump starting can be obtained at any
qualified specialist workshop.
Jump-starting
259
Breakdown
assistance
Z
Содержание B 250 e 2015
