Mercedes-Benz B 250 e 2015, Руководство пользователя

Страница: 243 / 293

X
Make sure that the windscreen wipers are
switched off.
X
Pull release lever : on the bonnet.
The bonnet is released.
X
Reach into the gap between the bonnet and
the radiator trim and press bonnet catch
lever ; to the left.
X
Raise the bonnet.
X
Pull support strut ? out of bracket A .
X
Lift up support strut ? and insert it into yel-
low retaining clip = .
Closing the bonnet
X
Raise the bonnet slightly and, at the same
time, remove support strut ? from yellow
retaining clip = .
X
Swing support strut ? down and press it into
bracket A until it engages.
X
Lower the bonnet and let it fall from a height
of approximately 20 cm.
X
Check that the bonnet has engaged properly.
If the bonnet can be raised slightly, it is not
properly engaged. Do not press the bonnet
closed. Open the bonnet again and close it
with a little more force.
Checking and adding other service
products
Checking the coolant level
G
WARNING
The cooling system is pressurised, particu-
larly when the engine is warm. If you open the
cap, you could be scalded if hot coolant
sprays out. There is a risk of injury.
Let the engine cool down before you open the
cap. Wear gloves and eye protection. Open
the cap slowly to release the pressure.
!
The coolant level must only be checked and
corrected when the engine has cooled down
(coolant temperature under 40 †). Checking
the coolant level when the coolant tempera-
ture is over 40 † can lead to damage to the
engine or engine cooling system.
X
Park the vehicle on a level surface.
Only check the coolant level when the vehicle
is on a level surface and the drive system has
cooled down.
X
Turn the key to position 2 in the ignition lock
(
Y
page 126).
X
Check the coolant temperature display in the
instrument cluster.
The coolant temperature must be below
40 †.
X
Turn the key to position 0 in the ignition lock
(
Y
page 126).
X
Slowly turn cap : anti-clockwise to allow
excess pressure to escape.
X
Turn cap : further anti-clockwise and
remove it.
If the coolant is at the level of marker bar =
in the filler neck when cold, there is enough
coolant in coolant expansion tank ; .
240
Engine compartment
Maintenance
and
care