Melco Advantage 18, Руководство по эксплуатации

Страница: 43 / 98

This Y Move positions the needle to the rear of the embroidery field. If the value was negative, the
Y Move would position the needle to the front of the embroidery field.
9. Press [ENTER].
10. Press [START]. The machine moves in both the X and Y axes to reposition the hoop.
After the Move Menu repositions the hoop, use the Trace Menu to verify the design fits in the
embroidery field, then press [ENTER] and then [START] to begin embroidering.
NOTE: If the LCD displays: MACHINE RUNNING, either a job is in progress and must be canceled
(see Reset Menu); or a move has been entered but not executed using the [START] key.
Trim Menu
When designs are created, trim commands may be included as part of the design. When the
Advantage 18 reads these commands, a trim occurs automatically. The trimmer function performs
when it encounters:
•
A color change
•
A set of commands called a trim dataset
•
The start and the end of the design
•
The number of consecutive jump stitches set in the jump count option
•
A trim immediate selection, if the machine is not embroidering
•
A change thread selection, if the machine is not embroidering
Setting the Options
Scroll through the top level menus, or press [ENTER] from the Head Timing Menu to reach the Trim
Menu.
Use the Trim Menu only when the machine is idle. If you try to enter the Trim Menu while the
machine is embroidering, you will receive the error message: MACHINE RUNNING.
1. Press [MENU] until the LCD displays: TRIM MENU.
2. Press [ENTER].
Trim Immediate
3. Press [
⇓
] and the LCD displays: TRIM IMMEDIATE. Press [ENTER] to activate the trimmer. Trim
Immediate can only be activated when the embroidery head is stopped.
Jump Count
4. Press [
⇓
] again and the LCD displays: JUMP COUNT. This option allows you to select the number
of consecutive jump stitches that will force an automatic trim. The machine trims before the
jump stitches occur. The default jump count is 8.
Setting the Options 4 - 7
110265-01, Rev. A 4. The Customizing Menus