Meech AHU-CL1, Руководство по эксплуатации, Страница: 77 / 102

AHU-CL1 Manual
Page 77 of 102
How to check the finger plastic for wear and damage
The plastic is hard wearing but eventually may require changing. It is important to change the plastic
before it fails as this will hamper the cleaning performance of the VacClean when using smaller web
sizes.
To check the plastic, unscrew the two countersunk fixings from the operator end of the VacClean head
and remove the bar holding the plastic in place
Once the bar has been removed the plastic can be examined looking for wear or stress marks. If
damaged it should be replaced, the part number for this can be found in the spares and wear part of the
manual.
Once checked or replaced it should be fitted back into place.
Checking the filter bag
The AHU-CL1 has a filter bag warning signal which will be triggered when the bag begins to fill with
contamination.
However, it is always good to periodically check the bag for damage and wear. This can be done with a
visual inspection of the bag once a week or after a period of particularly high usage or contamination
levels.
How to remove the filter bag can be found in the filtration section of the manual.
Quarterly Maintenance checks
As well as the weekly checks it is good to check over the system more thoroughly every quarter. These
checks include:
1. Faceplate Wear or Damage
2. Brush Wear or Damage
3. Filter compartment clean
4. Cooling filter inlet clean
5. 924 Bar Exterior clean
6. General exterior clean of System components