Meech AHU-CL1, Руководство по эксплуатации

Страница: 25 / 102

AHU-CL1 Manual
Page
25
of
102
System Installation Mechanical
CAUTION
Meech AHU-CL1 and VacClean system should only be Installed in the Canon ColourStream 8000 which
it is designed for. If the AHU-CL1 and VacClean is used in any other way than instructed in this manual,
it will be considered improper use.
Suggested Order of Installation
This system can be installed in various orders, we would advise that the following order is followed to
allow the greatest ease of install.
1. Install the Rear Manifold
2. Install the Side Slide Rails
3. Install the Top VacClean Manifold (and bottom if applicable)
4. Fit the mounting Carriers
5. Install the Toggle latches
6. Mount the AHU-CL1
7. Connect the 924 bars
This order can be done in different ways however the installation guide over the next few pages has
been written with the above order in mind.
Installation Procedure
Installing the Rear Manifold
The Rear Manifold has 4 mounting flanges each with two holes. These are designed to line up with
threaded holes in the machines plate (these should be put in by the customer). All drawings for the hole
positions are located in the rear of the manual under the Technical Drawings heading.
Using M5 Screws align the holes in the top flange with the threaded holes in the machine plate, fit the
two M5 screws loosely.
Mounting
Flanges
Figure 34 - Rear Manifold Mounting Flanges