Meech AHU-CL1, Руководство по эксплуатации

Страница: 31 / 102

AHU-CL1 Manual
Page
31
of
102
To check the brushes this can be done easily with a sheet of plastic or paper and visually checked to be
0.5-1mm below the face of the face plate.
The VacClean brushes should be 0.5mm-1mm lower than the face of the stainless polished face plates. If
this is not the case the brushes should be adjusted up or down accordingly.
This can be done by loosening the 3 button head screws retaining the brushes and moving them to the
correct location, then retightening the screws.
Once the VacClean has been fitted it is best to check that it is level with the Printer frame and there is a
good sealed connection between the rear of the VacClean ducting and the Rear Duct Manifold, show
below with red arrows
-
0.5mm Gap
Figure 46 - VacClean 0.5mm Brush Gap
Figure 47 - Join between Rear Manifold and VacClean Ducting