Meech AHU-CL1, Руководство по эксплуатации

Страница: 30 / 102

AHU-CL1 Manual
Page 30 of 102
Holding the VacClean manifold from below align the 3 studs protruding from the Rear manifold with 3
holes in the VacClean duct mounting plate.
Fit the two front mounting screws and spacer. Tighten to allow the VacClean to be held securely in place
The brush height should now be checked on the unit. The brushes are set before the system leaves
Meech but final adjustment can be done at the point of installation if required.
The seal at the rear of the VacClean should be checked to ensure it is mating all around the ducting
between the rear manifold and VacClean ducting.
Figure 45 - Screwing front bracket in place with spacer
Figure 44- Getting Top Manifold in rough position