Matrox Iris GT MIL, Инструкция по установке и техническое руководство, Страница: 156 / 256

156 Appendix G: Reading the LEDs
• Status LED. This LED shows the general activity of your Matrox Iris GT.
Power LED error codes
Whenever the User LED is blinking red while the Power LED is also red, an error
has occurred. These are errors declared by the bootloader at boot time. A text
version of the error message can be seen among the messages sent to the COM
port by the Matrox Iris GT. Note that this assumes the
POST string print to
memory option is enabled on the Boot settings page, which can be accessed from
the Administration utility page of the Matrox Iris portal website.
The following only applies when the Power LED stays red while the User LED
blinks red.
LED Description
Off There is no power.
Red Matrox Iris GT is booting.
Orange The Matrox Iris GT acquisition section is initializing or a MIL program is either waiting for a
trigger or using image files from disk.
Green The Matrox Iris GT acquisition section is grabbing an image.
User LED blink sequence Error
6-1-1-1-1 Invalid error or unknown error.
6-1-1-1-2 Boot ROM checksum error.
6-1-1-1-3 CMOS error.
6-1-1-1-4 CMOS data error.
6-1-1-2-1 Maximum boot failure count reached.
6-1-1-2-2 Memory initialization error.
6-1-1-2-3 FPGA Load firmware error.
6-1-1-2-4 ROM interface block error.
6-1-1-3-1 CPU microcode update error.
6-1-1-3-2 Memory bus data line error.
6-1-1-3-3 Memory bus address line error.
6-1-3-1-1 RTC error.
6-1-3-1-2 100/1 GBase T Ethernet controller error.
6-1-3-1-3 Solid state device size error.
6-1-3-1-4 RAM row size error.