Matrox Iris GT MIL, Инструкция по установке и техническое руководство, Страница: 145 / 256

Open-wire connectors reference 145
Breakout board’s output connector
The breakout board’s output connector is a series of 10 wire terminals. They
connect to your third-party devices so these devices can receive auxiliary output
signals and controlled-current output from your Matrox Iris GT, via an open-wire
Each auxiliary output signal sent to a third-party device requires two wires: one
to carry the signal from your Matrox Iris GT, and one to connect the external
pull-up resistor to +VDC.
For information on using the breakout board’s output connector, refer to the
Routing Matrox Iris GT outputs section, earlier in this appendix.
The pinout for the breakout board’s output connector is as follows:
J21
J22 J23 J24 J25 J26 J27 J28 J29 J30
+
VDC
+
VDC
+
VDC
+
VDC GND
OUT0
OUT1
OUT2 OUT3
STROBE
Wire terminal Description Matrox Iris GT signal sent Routed through the
smart camera connector
J21 Industrial auxiliary signal 4 (output). AUX(STB)_OPENC_OUT4 J8
J22 +VDC supply.
J23 Industrial auxiliary signal 5 (output). AUX(STB)_OPENC_OUT5 J9
J24 +VDC supply.
J25 Industrial auxiliary signal 6 (output). AUX(USER)_OPENC_OUT6 J10
J26 +VDC supply.
J27 Industrial auxiliary signal 7 (output). AUX(USER)_OPENC_OUT7 J11
J28 +VDC supply.
J29 Controlled-current output. This wire terminal connects to an
array of LEDs without series resistors (that is, a
controlled-current array of LEDs). Connect the ground of the
LED lighting device to the J30 wire terminal. CCS J12
J30 Ground for the controlled-current output.