Master Forge 0098162, Руководство пользователя

Страница: 107 / 114

31
CARE AND MAINTENANCE
Bulb specification
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
Please contact customer service at
1-800-963-0211 for assistance on bulb replacement
information.
Replacing Battery for LED Panel Light
1. Open the LED battery box on the right panel in the
cabinet.
2. Open the battery box and replace the 9 V battery.
3. When installing new batteries, ensure they are
installed with the proper polarity.
4. Close the cover of the battery box.
WARNING:
1. To protect against electric shock, do not immerse cord or plugs in water or other liquid.
2. Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or
taking off parts.
3. Do not operate any outdoor cooking gas appliance with a damaged cord, plug, or after the
appliance malfunctions or has been damaged in any manner. Contact the manufacturer for
repair.
4. Do not let the cord hang over the edge of a table or touch hot surfaces.
5. Do not use an outdoor cooking gas appliance for purposes other than intended.
6. When connecting, first connect plug to the outdoor cooking gas appliance then plug
appliance into the outlet.
7. Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas
appliance.
8. Never remove the grounding plug or use with an adaptor of 2 prongs.
9. Use only extension cords with a 3 prong grounding plug, rated for the power of the equipment,
and approved for outdoor use with a W-A marking.
!
WARNING
The light glass cover should not be in contact with water or any other liquid when it’s
warm. Sudden change of temperature may cause cracks on glass cover.
!
WARNING
To ensure continued protection against electric shock:
1. Connect to properly grounded outlets only.
2. Do not expose to rain.
3. Keep extension cord connections dry and off the ground.
CUIDADO Y MANTENIMIENTO
ADVERTENCIA
/DFXELHUWDGHYLGULRGHODOiPSDUDQRGHEHHVWDUHQFRQWDFWRFRQHODJXDQLFRQ
RWURVOtTXLGRVFXDQGRHVWpFDOLHQWH8QFDPELREUXVFRGHWHPSHUDWXUDSXHGHRFDVLRQDU
JULHWDVHQODFXELHUWDGHYLGULR
ADVERTENCIA
3DUDJDUDQWL]DUXQDSURWHFFLyQFRQWLQXDFRQWUDGHVFDUJDVHOpFWULFDV
&RQHFWHVyORDWRPDFRUULHQWHVFRQODGHELGDSXHVWDDWLHUUD
1RORH[SRQJDDODOOXYLD
0DQWHQJDODVFRQH[LRQHVGHODH[WHQVLyQHOpFWULFDVHFDV\VHSDUDGDVGHOVXHOR
(VSHFL¿FDFLRQHVGHODERPELOOD
Tipo de bombilla: h alógena
Vataje: 10 vatios por bombilla
Voltaje: 12 voltios
Póngase en contacto con el Servicio al cliente al para obtener ayuda sobre el
reemplazo de las bombillas.
ADVERTENCIA:
1. Para protegerse contra descargas eléctricas, no sumerja el cable o el enchufe en el
agua u otro líquido.
2. Desenchufe la unidad cuando no la utilice y antes de limpiarla. Déjela enfriar antes de ponerle
o quitarle partes.
3. No opere ningún aparato con el cable o enchufe dañados, o después de que el aparato haya
fallado o se haya dañado de cualquier manera.
4. No deje que el cable cuelgue fuera del borde de la mesa o mostrador, ni que toque
VXSHU¿FLHVFDOLHQWHV
1RXWLOLFHHODSDUDWRSDUD¿QHVGLIHUHQWHVDORVSUHYLVWRV
$OFRQHFWDUFRQHFWHSULPHURHOHQFKXIHHQHODSDUDWRGHFRFFLyQDJDVHQH[WHULRUHV\OXHJRHO
enchufe en el tomacorriente.
7. Use s o lo con GFI (interruptor de fallo de tierra) del circuito protegido.
1RUHWLUHQXQFDODFODYLMDGHFRQH[LyQDWLHUUDGHOHQFKXIHQLXVHDGDSWDGRUHVGHFODYLMDV
8VHV
o
ORH[WHQVLRQHVFRQHQFKXIHGHFODYLMDVGHFRQH[LyQDWLHUUDFDOL¿FDGDVSDUDHVWH
HTXLSR\DSUREDGDVSDUDHOXVRH[WHULRUFRQXQDHWLTXHWDGH:$
5HHPSOD]RGHODEDWHUtDGHOSDQHOGHOX]/('
1. Abra la caja de la batería LED en el panel derecho
del gabinete.
2. Abra la caja de la batería y reemplace la batería
de 9 voltios.
3. Al instalar una batería nueva, asegúrese de colocarla
con la polaridad adecuada.
4. Cierre la tapa de la caja de la batería.
107