V.033114
M&R Companies 1N 372 Main St. Glen Ellyn, IL 60137 USA
59
Tel: +630-858-6101 Fax: +630-858-6134
6.2.4
Print Head Adjustments
WARNING:
Before entering between print heads, always push in Emergency Stop button
and disconnect Cycle Interruption Cords. Refer to the beginning of this section for detailed
information.
Print Head
Micro Register
Place the switch for the rear screen frame clamps
on the print head control panel in the
OFF
position. This allows the screen frame to move
freely during micro-register adjustments.
Check the micro-register adjustment knobs to be
sure that they are not binding. The knobs should
have sligh
t play (1/32”) in both the clockwise and
counterclockwise directions.
Unlock both the right and the left micro-register
locking handles.
The two micro-register knobs (1) at the front of the
screen frame holder assembly are used to move
the screen frame from the front to the rear. The
micro-register knob (2) on the right side of the
screen holder assembly is used to move the
screen frame from the left to the right.
The micro-register adjustments allow for
movement of 1/4” from the zero or center position
for an overall range of 1/2” right to left and front to
rear.
When you have completed the micro-register
adjustments, check to be sure the adjustment
knobs still have the 1/32” play in both the
clockwise and counter clockwise directions. Now
lock the micro-register locking handles securely.
Place the switch for the rear screen frame clamps
on the print head control panel in the
ON
position.
