MAHA SA 2 Euro, Руководство по эксплуатации и техническому обслуживанию

Страница: 29 / 134

Eurosystem / Profi-LON Profi-LON Operation
3.10 D1 E101BA1-GB09
3.3.3 Manual Weight Entry
The test stand can only conduct a final evaluation (calculation of deceleration in %) with a
known vehicle weight. If the test lane is not equipped with a weighing device manually enter the
vehicle weight using the following keys on the remote control.
IFB3
Profi-LON
IFB3
Profi-Eurosystem
Auto-Off-key
Digit keys
bis bis
Delete
Confirm
1 After completion of brake test exit roller and set press Auto-Off key to complete
measurement.
→
Pointers return to zero point on brake tester scale.
→
ON lamp goes out.
2 Manual entry of vehicle weight using remote control
A vehicle weight of e.g. 1380 kg is entered with the digit keys 1-3-8-0.
→
Left-hand pointer goes to 1.38 kN (corresponds with 1380 kg).
If the wrong weight was entered use the Delete key. Then enter the correct weight.
3 Press Confirmation key
→
Final evaluation is conducted.
Brake force of service brake is indicated on left side of display, entered weight on right side.
→
ON lamp lights up.
If the wrong weight was entered use Auto-Off key to delete. Then enter the correct weight.
3.3.4 Printout of Measurements
The max. brake values can be printed out during brake test already. After final evaluation the
total measurement values can be printed out (test protocol). Use the following keys.
IFB3
Profi-LON
IFB3
Profi-Eurosystem
Printout during the brake
test
Printout of the final
evaluation