2.7
Configuration Using HART
A HART (Highway Addressable Remote Transducer)
remote unit, such as a HART communicator, can be used to
provide a communication link to the ECLIPSE Model 700
transmitter. When connected to the control loop, the same
system measurement readings shown on the transmitter are
also shown on the communicator. The communicator can
also be used to configure the transmitter.
The HART communicator may need to be updated to
include the ECLIPSE Model 700 software (Device
Descriptions). Refer to your HART Communicator Manual
for update instructions.
One can also access configuration parameters using
PACT
ware
and the Model 700 DTM, or using the AMS
with EDDL.
2.7.1 Connections
A HART communicator can be operated from a remote
location by connecting it to a remote junction or by con-
necting it directly to the terminal block in the wiring com-
partment of the ECLIPSE transmitter.
HART uses the Bell 202 frequency shift keying technique
of high-frequency digital signals. It operates on the 4–20
mA loop and requires 250
Ω
load resistance. A typical con-
nection between a communicator and the ECLIPSE trans-
mitter is shown at left.
2.7.2 HART Communicator Display
A typical communicator display is an 8-line by 21-character
LCD. When connected, the top line of each menu displays
the model (Model 700) and its tag number or address. For
detailed operating information, refer to the instruction
manual provided with the HART communicator.
2.7.3 HART Revision Table
Model 700 1.x
HART Version
HCF Release Date
Compatible with 700 Software
Dev Rev 1, DD Rev 1 October 2019
Version 1.0 and later
2.7.4 HART Menu – Model 700
The ECLIPSE transmitter HART menu trees are shown in
the following pages. Open the menu by pressing the
alphanumeric key 4, then Device Setup, to display the
second-level menu.
+
-
Control
Room
Display
Current
Meter
Power
Supply
Junction
RL> 250
Ω
24 VDC (250 ohms minimum
HART connections
Transmitter
PC with HART
Serial Interface
31
BE 57-660 Eclipse Model 700 Guided Wave Radar Transmitter
