19
BE 57-660 Eclipse Model 700 Guided Wave Radar Transmitter
2.6
Configuration
Although the ECLIPSE Model 700 transmitter can be
delivered pre-configured from the factory, it can also be
easily reconfigured in the shop or at the installation using
the local LCD/Keypad or PACT
ware
/DTM. Bench config-
uration provides a convenient and efficient way to set up
the transmitter before going to the tank site to complete
the installation.
Before configuring any transmitter, collect all operating
parameters information (refer to Section 1.1.2).
Apply power to the transmitter and follow the step-by-step
procedures below for the menu-driven transmitter display.
Refer to Sections 2.6.2 and 2.6.4.
Information on configuring the transmitter using a HART
communicator is given in Section 2.7, Configuration
Using HART.
2.6.1 Bench Configuration
The ECLIPSE Model 700 transmitter can be easily config-
ured at a test bench by connecting a standard 24 VDC
power supply directly to the transmitter terminals.
When using a HART communicator for configuration, a
minimum 250-ohm line load resistance is required. Refer
to your HART communicator manual for additional
information.
