2.0
Complete Installation
This section provides detailed procedures for properly
installing, wiring, and configuring the ECLIPSE Model 700
Guided Wave Radar Level Transmitter.
2.1
Unpacking
Unpack the instrument carefully. Make sure all components
have been removed from the packing material. Check all
contents against the packing slip and report any discrepan-
cies to the factory.
Before proceeding with the installation,
• Inspect all components for damage. Report any damage to
the carrier within 24 hours.
• Make sure the nameplate model number on the transmitter
agrees with the packing slip and purchase order.
• Record the model and serial numbers for future reference
when ordering parts.
Model Number
Serial Number
NOTE:
To avoid moisture ingress in the housing, covers should be fully
tightened at all times. For same reason, conduit entries should
be properly sealed.
2.2
Electrostatic Discharge (ESD)
Handling Procedure
MAGNETROL electronic instruments are manufactured to
the highest quality standards. These instruments use elec-
tronic components that may be damaged by static electricity
present in most work environments.
The following steps are recommended to reduce the risk of
component failure due to electrostatic discharge.
• Ship and store circuit boards in anti-static bags. If an anti-
static bag is not available, wrap the board in aluminum
foil. Do not place boards on foam packing materials.
12
BE 57-660 Eclipse Model 700 Guided Wave Radar Transmitter
