Magnetek FLEX EX, Инструкция по эксплуатации

Страница: 74 / 120

Page 73
9.43 Program PB1 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter PB1 Ramp setting.
3) Press “ ↑ ” and “ ↓ ” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “ → ” button to enter.
4) Press “ ↑ ” and “ ↓ ” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB1 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB1 RAMP”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
9.44 Program PB2 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter PB2 Ramp setting.
3) Press “ ↑ ” and “ ↓ ” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “ → ” button to enter.
4) Press “ ↑ ” and “ ↓ ” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB2 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB2 RAMP”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
9.45 Program PB3 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter PB3 Ramp setting.
3) Press “ ↑ ” and “ ↓ ” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “ → ” button to enter.
4) Press “ ↑ ” and “ ↓ ” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB3 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB3 RAMP”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.
9.46 Program PB4 Ramp (RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→ ” button to enter PB4 Ramp setting.
3) Press “ ↑ ” and “ ↓ ” button to scroll and select “ACC” for acceleration and
“DEC” for deceleration and press “ → ” button to enter.
4) Press “ ↑ ” and “ ↓ ” button to change value.
5) Press “BACK” button to go back to step 3.
6) Exit Program PB4 Ramp by pressing the “BACK” button until the cursor is
shown next to “PB4 RAMP”.
7) Press “ ↑ ” and “ ↓ ” button to scroll through other Flex EP-H settings.