Page 51
B. Program receiver:
1) When programming the receiver the power must be turned on with receiver
MAIN relays deactivated.
2) Press “
→
” button to enter IR setting.
3) Press READ button to store the receiver info into the programmer. If the
screen shows “READ OK” the transfer is completed.
4) Press WRITE button to transfer the stored info into the receiver. If the screen
shows “WRITE OK” the transfer is completed. The receiver will restart
automatically after 2 seconds.
5) Exit Program IR by pressing the “BACK” button until the cursor is shown
next to “Program”.
6) Press “
↑
” and “
↓
” button to scroll through other Flex EP-H settings.
Note: When performing infrared programming make sure the distance between the
programmer and the transmitter or receiver is within 10cm.
9.2 Program Serial Number (TX & RX)
1) Make sure the I-Chip is connected to the programmer.
2) Press “
→
” button to enter Serial Number setting.
3) Press “
↑
” and “
↓
” button to change serial number as a whole or…
4) Press “
→
” button to go to the 1
st
digit on the far left of the serial number.
5) Press “
↑
” and “
↓
” button to change numeric value.
6) Press “
→
” button to go to the next digit to the right and repeat step 5.
7) Press BACK button to go back to step 3 or 4.
8) Exit Program Serial Number by pressing the “BACK” button until the cursor
is shown next to “S/N:”.
9) Press “
↑
” and “
↓
” button to scroll through other Flex EP-H settings.
9.3 Program System Type (TX & RX)
System Type is associated with functions such as tandem operation, random
access operation, multi-receiver operation, etc... Please do not alter the
factory settings unless authorized to do so.
Содержание FLEX EX
