215794
94
Revision A
5.5
Displaying Active Cab Display Lockouts
The Operator can generate a list of all windrower features which have been locked out by accessing the cab display
module
’
s (CDM) VIEW CONTROL LOCKS sub-menu.
1011786
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 5.79: CDM Programming Buttons
1.
Turn the ignition key to the RUN position, or start the
engine.
2.
Press PROGRAM (A) and SELECT (C) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.
•
NO/YES will appear on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? will appear on the upper line.
1011821
CXXX
EXXX
VIEW CONTROL LOCKS
NO/YES
B
A
Figure 5.80: Control Locks
4.
Press SELECT (B) until VIEW CONTROL LOCKS? appears on
the upper line.
•
NO/YES will appear on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
HEADER TILT will appear on the upper line.
•
The control switch status will appear on the lower line.
The hours displayed indicate when a switch was
enabled or locked.
1011822
CXXX
EXXX
DRAPER SPEED
575.1 HRS ENABLED
D
C
B
A
Figure 5.81: Control Locks
6.
Press left arrow (B) or right arrow (C) to cycle between
control switch lockouts. The displayed control switches are
as follows:
•
HEADER TILT
•
HEADER FLOAT
•
REEL FORE/AFT
•
DRAPER SPEED
•
AUGER SPEED
•
KNIFE SPEED
•
DISK SPEED
•
REEL SPEED
NOTE:
Not all control lock options apply to every type of header.