215794
110
Revision A
5.9
Troubleshooting Header Problems
Refer to this section if you are encountering difficulties configuring header features in the cab display module (CDM).
5.9.1
Testing Header Up/Down Activate Function Using Cab Display Module
The cab display module (CDM) can be used to change the height of the attached header, rather than using the height
controls on the ground speed lever (GSL). Perform a test to ensure this feature is functioning properly.
NOTE:
•
Before performing this procedure, the header must be attached to the windrower. The CDM automatically adjusts its
programming for each header.
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1011772
C###
E###
WINDROWER SETUP?
NO/YES
A
B
Figure 5.115: CDM Programming Buttons
1.
Start the engine.
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode. Press SELECT (B).
•
WINDROWER SETUP? will appear on the upper line.
1011785
CXXX
EXXX
DIAGNOSTIC MODE?
NO/YES
A
B
Figure 5.116: Diagnostic Functions
3.
Press SELECT (B) until DIAGNOSTIC MODE? appears on the
upper line.
•
NO/YES will appear on the lower line.
4.
Press right arrow (A) to select YES. Press SELECT (B).