215794
118
Revision A
1011793
CXXX
EXXX
DRAPER DRV SPD XXXX
D 0 P 0
- +
D
D
B
A
C
E
Figure 5.134: Draper Drive
7.
Press SELECT (E) until DRAPER DRV SPD XXXX appears on
the upper line.
8.
Press and hold HAZARD button (C).
•
Press left arrow (B) to decrease the draper speed.
•
Press right arrow (D) to increase the draper speed.
IMPORTANT:
Do
NOT
overspeed the drapers.
NOTE:
Ensure that the draper drive is working properly.
9.
Release the HAZARD (C) button. The drapers will stop.
10. Press PROGRAM (A) to exit programming mode or press
SELECT (E) to proceed to the next header function option.
5.9.6
Testing Reel Drive Circuit Activate Function Using Cab Display Module
The cab display module (CDM) can be used to test the reel drive circuit, rather than using the controls on the operator
’
s
station.
IMPORTANT:
Do
NOT
overspeed the reel drive. Overspeeding can lead to vibration, belt failures, or other overspeeding-related
problems.
NOTE:
•
The header must be attached to the windrower to follow this procedure. For more information, refer to
Headers to M Series Windrower, page 147
•
This procedure does not apply to windrowers with attached rotary disc headers.
•
The engine must be running to perform this procedure.
DANGER
Ensure that all bystanders have cleared the area.
1.
Start the engine.
1022036
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
Figure 5.135: CDM Programming Buttons
2.
Press PROGRAM (A) and SELECT (B) simultaneously on the
CDM to enter programming mode.
•
WINDROWER SETUP? will appear on the upper line.