215794
186
Revision A
1029675
B
A
C
Figure 8.96: Header Support
4.
Lift header support (A) and place 2 x 4 in. blocks (B) under
the header support. A total of four 2 x 4 in. blocks (B) will
be necessary to raise the boot up into field position. Ensure
the boot
’
s bottom edge (C) is parallel with the ground.
Repeat for the opposite side.
NOTE:
Do
NOT
stack blocks (B) crosswise; doing so can make the
header unstable. Stack blocks (B) so that the edges of the
blocks are flush with each other.
1029714
A
B
Figure 8.97: Float Linkage
5.
Remove the float engagement pin from hole (A) to
disengage the float springs. Insert the float engagement pin
into storage hole (B). Secure the engagement pin with the
lynch pin.
IMPORTANT:
To prevent damage to the lift system when lowering the
header lift linkages without a header or a weight box
attached to the windrower, ensure that the float
engagement pin is installed in storage hole (B) and
NOT
in
engaged position (A).
6.
Repeat the previous step for the other float
engagement pin.
1008925
A
Figure 8.98: Ground Speed Lever
DANGER
Ensure that all bystanders have cleared the area.
7.
Start the engine and activate HEADER DOWN button (A) on
the ground speed lever (GSL) to fully retract the header lift
cylinders.