215794
26
Revision A
1005768
Figure 3.14: Widest Tread Width Shown
4.
Ensure the caster wheels are positioned at equal distances
from the center of the windrower.
1008892
A
B
D
C
Figure 3.15: Walking Beam
5.
Position bracket (A) as shown.
6.
Install two 3/4 in. x 2-3/4 in. hex head bolts (B) at the back
outboard location, and install two 3/4 in. x 2-1/4 in. hex
head bolts (C) at the back inboard location. Tighten the
bolts until they are snug; do not torque the bolts yet.
7.
Install two 3/4 in. x 2-1/4 in. hex head bolts (D) on the
underside of the beam. Tighten the bolts until they
are snug; do not torque the bolts yet.
8.
Torque all bolts (B) and (C) at the back location to 447 Nm
(330 lbf·ft).
9.
Torque all bolts (D) on the underside to 447 Nm (330 lbf·ft).
10. Lower the windrower to the ground.
IMPORTANT:
Torque all bolts to 447 Nm (330 lbf·ft) after the first 5 hours
of operation. Repeat the torquing procedure after 10 hours
of operation.
11. Remove the banding and wooden blocks from the center of
the walking beam.