Lupus Electronics LUPUSEC-XT1, Руководство пользователя

Страница: 82 / 130

82

Entrance signal on / off
With this function active, the siren will sound confirmation signals for the duration
of the defined delay until the system is armed.
To disable the warning signal of the siren(s) upon entry/exit, proceed as follows:
o
Click “Entrance signal”  “Off”.
o
Then click “OK” below.
Note:

These three settings are transmitted only, but not permanently stored in this
menu. After their transmission, all three settings are ON again - but they were
stored in the sirens, after they transmitted the confirmation signal.

In addition, please observe that the configuration is transmitted to all currently
connected and active external sirens. If you want to configure several sirens
differently, you should install these sirens later or just disconnect these sirens
from the power supply temporarily. It is impossible to read out the current siren
configuration.
Battery:
The wireless indoor siren requires 4 D-cell alkaline batteries. The average battery life
is two years (depending on the usage).
Warning sounds and signals of the indoor siren:
Signal tone Signal lights
Arm/Home 1 beep* The 3 LEDs light up once
Disarm 2 beeps* The 3 LEDs light up once one after another
Arm (low battery) 5 beeps The 3 LEDs light up three times
Disarm (low battery) 5 beeps The 3 LEDs light up twice one after another
Arm (tamper) 5 beeps The 3 LEDs light up three times simultaneously
Disarm tamper) 2 beeps* The 3 LEDs light up twice one after another
Pre-alarm 3 seconds beep The 3 LEDs light up twice one after another
Tamper alarm Continuous beeps The 3 LEDs flash constantly simultaneously
Entrance/exit signal tone
Continuous beeps until
time has elapsed
Nothing