Lupus Electronics LUPUSEC-XT1, Руководство пользователя

Страница: 118 / 130

118
In-wall relay with electric meter
1.
LED indicator
On: relay on
Off: relay off
Flashes twice: signal transmission
2.
Test button
Keep the button pressed for 10 seconds to send the
learn signal to the control unit. Pressing the button
briefly activates or deactivates the relay.
3.
230 V input
4.
230 V output
Caution:
Only a certified electrician or electrically instructed person knowing and
understanding current and the inherent hazards is allowed to perform the installation.
Improper handling may cause electric shock!
Put the in-wall relay with electric meter into operation
1.
Connect the 230 V supply line (brown = L and blue = N) to the input (3).
Grounding (green-yellow) is not required.
2.
Connect the 230 V power cable (brown = L and blue = N) to the output (4)
3.
Open the control unit menu  Sensors  Add and click Start.
4.
Keep the Test button (2) pressed for approx. 10 seconds. The relay transmits the
learn code and the LED flashes twice after about 5-6 seconds.
5.
Add the in-wall relay to the sensor list.
Range test:
1.
Open the control unit menu

Sensors

Range and press Start.
2.
Press the Test button of the relay.
3.
The sensor and the signal strength should be indicated.
Note:

The relay can be activated and deactivated manually on the website.

You can save dynamic or scheduled programming in the Automation menu.

After a power failure, the in-wall relay returns to the last state before the power
failure.

The in-wall relay is incompatible with the wireless repeater and cannot be saved
in the backup configuration file.

The sensor list indicates the power consumption.