Lupus Electronics LUPUSEC-XT1, Руководство пользователя

Страница: 78 / 130

78
8.
If the siren was found, the control unit sounds a signal tone for confirmation.
9.
Set SW1 back to OFF . Exit the learn mode.
10.
Test the siren function by simulating an alarm or actuating the tamper contact.
11.
Caution: The siren is very loud (104 dB)! Deactivate the sound either by
disarming the alarm system or by interrupting the power supply.
12.
Set SW7 to ON, if you want battery monitoring.
13.
Open the menu Sensors  Siren in the control unit and specify the conditions to
activate the siren in “External siren control”.
14.
In the Range menu, verify that the signal strength at the desired location is
sufficient. Click on Start and activate SW1 in the siren (only) for the range test.
The higher the indicated number, the better the reception (1-9).
Siren settings:
Configure all the external sirens via the menu “Sensors”
 “Devices”.

Tamper contact on / off
Deactivates the tamper contact of all currently connected external sirens (installed in
addition to the control unit)
for one hour (useful e.g. to change the batteries). To
deactivate the tamper contact of the siren(s), please proceed as follows:
o
Click “Tamper contact”  “Off”.
o
Then click “OK” below.
Note :
If the tamper contact is disabled, the siren does not transmit status updates to the
control unit anymore for as long as it is disabled. For that period, you can also not
see the current state of the tamper contact via Sensors
 List.
Caution!
If you open the siren without deactivating the tamper contact before, the audio alarm
of the siren will be activated even if the siren is not integrated in the control unit
anymore! In that case, you should wear ear protection and disconnect the power
supply as quickly as possible.

Confirmation signal on / off (Arm/Disarm)
With this function active, the siren will sound a signal when arming/disarming.
To disable the confirmation signal of the siren(s) upon arming/disarming, proceed
as follows:
o
Click “Confirmation (arm/disarm) signal”  “Off”.
o
Then click on “OK” below.
Note:
If the tamper contact of the siren is open when arming, five brief signal tones in quick
succession will sound despite the confirmation signal being disabled.

Entrance signal on / off
With this function active, the siren will sound confirmation signals for the duration
of the defined delay until the system is armed.
To disable the warning signal of the siren(s) upon entry/exit, proceed as follows:
o
Click “Entrance signal”  “Off”.
o
Then click “OK” below.