Hand-Crimping Tool
....................................................................................................................................................................................................................................
Overview
This section covers how to use the frame assembly of the
hand-crimping tool 54334–1 and the die sets explains and the
crimping procedure.
References
“Mounting of the Shielded Cable Hood for a D-SUB Connector”
(A-7)
Description of the
Crimping Sets
Each die set contains an anvil, a crimper (stationary), an inner-ferrule
positioner and an outer-ferrule stop, see figure below.
The die set simultaneously crimps the inner ferrule and the outer
ferrule onto the cable. The crimper remains stationary within the
tooling while the anvil moves during the crimping operation.
The dies are numbered and the positioners bear letter inscriptions
(*1). These markings allow the operator to select the appropriate die
and the appropriate positioner for the the crimping tool, see Table.
Crimping Die-Set for Hand-Crimping Tool
Legend:
1
Crimper (stationary)
2
Inner-ferrule positioner
3
Outer-ferrule stop
4
Anvil (moving die)
Overview of Cable Types, Hood Sets, Ferrules and Die Sets
Assembly Instructions
....................................................................................................................................................................................................................................
A - 2 0
Lucent Technologies - Proprietary
See notice on first page
365-312-761
Issue 1, May 2004
