LSIS XDL-L7NH Series, Руководство пользователя, Страница: 3 / 348

Introduction
iii
Introduction
Hello. Thank you for choosing LSIS XDL-L7NH Series.
This user manual describes how to use this product safely and efficiently.
Failure to comply with the guidelines outlined in this manual may cause personal injury or damage to
the product. Be sure to read this manual carefully before using this product and follow all guidelines
contained therein.
 The contents of this manual are subject to change without notice.
 The reproduction of part or all of the contents of this manual in any form, by any means or for
any purpose is strictly prohibited without the explicit written consent of LSIS.
 LSIS retains all patents, trademarks, copyrights and other intellectual property rights to the
material in this manual. The information contained in this manual is only intended for use with
LSIS products.
Safety precautions are categorized as either Warnings or Cautions, depending on the severity
of the precaution.
Precautions Definition
Danger
Failure to comply with these guidelines may cause serious injury or death.
Caution
Failure to comply with these guidelines may cause personal injury or property
damage.

Precautions listed as Cautions may also result in serious injury .
 Electric Safety Precautions
Danger
 Before wiring or inspection tasks, turn off the power. Wait 15 minutes until the charge
lamp goes off, and then check the voltage.
 Ground both the servo drive and the servo motor.
 Only specially trained technicians may perform wiring on this product.
 Install both the servo drive and servo motor before performing any wiring.
 Do not operate the device with wet hands.
 Do not open the servo drive cover during operation.
 Do not operate the device with the servo drive cover removed.
 Even if the power is off, do not remove the servo drive cover.
 Fire Safety Precautions
Caution
 Install the servo drive, the servo motor, and the regenerative resistor on non-
combustible materials.
 Disconnect the input power if the servo drive malfunctions.