53
Appendix D: Connecting Motion / Alarm Devices
Appendix D: Connecting Motion / Alarm Devices
You can enable Motion Detection and Alarm control from the Main Menu. You can also connect
additional motion sensor devices to the system (i.e. motion sensors, door/window sensors) with
a D-sub 9 connector (not included). Use a motion detector or sensor to send a signal to the
system to begin camera viewing and recording on the matching camera channel (when enabled
in the Menu).
NOTE:
Some soldering is required when using a D-sub 9 connector.
Installing a Sensor
To connect an external alarm sensor to the system:
1. Connect a
D-SUB 9
connector (not included) to the
ALARM I/O
port on the rear panel.
2. Connect Alarm-In wires to pins 1~4; connect NC wire to pin 6 connect NO open to pin 7.
3. Connect the ground wire to pin 9.
DVR
D-SUB 9 CONNECTOR
(Not Included)
SENSOR
(Not Included)
D-SUB 9 CONNECTOR
Pins 1-4
: Alarm input terminals receive
a signal from a device (i.e. Door or
Window Sensor).
Pins 6, 7: NO / NC
: Alarm Output
Terminals send a signal to another
device when an alarm input is
detected.
