Linde T 16, Руководство по эксплуатации

Страница: 41 / 53

3
6
0
8
0
4
2
5
1
1
-
0
5
0
4
Clean the hydraulic filter
- Put the lifting system into the down position.
- Clean the screen in the breather cap (1).
- Disconnect the hose (7).
- Unscrew the connector (2).
- Take out the filter assembly.
- Clean or replace the screen (3).
CAUTION
When removing the non-return valve, do not lose
the spring (4) and ball (5).
- Check that the seal is in good condition.
- Screw the connector (2) on and reconnect the hose (7).
Check the fluid level when you have completed this
operation.
NOTE
We recommand that this operation be carried out by your
distributor.
1
Maintenance Maintenance every 1000 hours
Inspection / replacement of the pump motor
brushes
- Remove the pump motor unit.
- Place the pump motor in a vertical position.
- Remove the four long bolts which hold the motor
together.
- Remove the bearing on the commutator side.
- Clean the motor using compressed air.
- Check that the commutator is not scored, and shows no
signs of sparking.
- Check the brushes.
- Replace if necessary.
- Refitting is the reverse of the sequence for removal. When
refitting the brushes, carefully lift them on to the
commutator surface.
NOTE
Always replace the brushes as a complete set.
DIMENSIONS
Pump motor: 0,8 and 1,0 kW
new length: 18 mm.
min. length: 10 mm.
We recommend leaving this operation to your local
representative.
Checking the mechanical fixing of compon-
ents
- Check for secure fitting of the sub-assemblies: motor /
reduction gear, load wheels, driven wheel and stabiliser
wheel.
- Check the tightness of the various nuts and bolts.
- Check that the fork arms are in good condition.
- Replace any defective items.
- Retouch paintwork if necessary.
https://www.besttruckmanuals.com/